I used the MicroMark PVA onto the shiny side of the foil after cutting a piece foil that would fit with some overlap. After force-drying the adhesive I rolled the tube onto the foil to start the wrap and then used …

I designed it to nominally require one Micromark Kadee shim, to allow for tolerances, slop in the chassis and trucks, etc. I also added a few locating features to pick up key points of the chassis, so that there …

Isopropyl alcohol removes any residual Goo Gone since all this surface is going to get MicroMark rivet decals. I would someday like to have the NWSL Sensi-press and Riveter embossing system, but until …

Like BOB2 said, the spikes can give you fits, I even bought a tool from MicroMark and still had problems. If you only need a few switches I recommend Signature Switch. If you need a boat load I recommend …

I used my MicroMark soldering block to hold the mast when soldering the first cross pieces. And here's the completed, unpainted antenna. To mount the antenna I used some photo-etched brass fret. I …

Scale Reproductions has one that's similar to the ones sold by MicroMark. I'm researching building the box to enclose the cellar window where I can open the window, but using a one-way dryer vent, keep …

Same goes for the trolley layout built be the owner of micromark. 3r especially high rail affords some of us the opportunity to get close to the level of 2r but the cost and space constraints limit the market …

The house made use of some left over Grandt Line doors and windows, and some brick paper I bought from MicroMark years and years ago. I bought it before I had settled on my methods for doing …

We are absolutely on the same page! As I moved up the training management ranks I missed the field more and more. My best job was the first one in industry where I was working directly with the folks …

Nov 30, 2020 · I pre-shaped the Bondic to give the rough curved shaped with a round sanding head on my MicroMark Power Sander. To finish it off I completed the fill with Tamiya Fine Filler.